Bitedit USB Dongle (with Single Pre-activated Module) ECU Calibration Software Module Toyota Denso Petrol 7

Module Toyota Denso Petrol 7

Software module for editing calibrations Denso Gen3 ECU of normal aspirated petrol Toyota | Lexus.

Supported engine types: A25A, A25B, M20A, M15A.

Supported filesize: 4Mb.

Available maps:

Air calculation: Injection in closed loop mode, Target air load

Limiters: Engine speed limitation

Exhaust temperature model: Target exhaust temperature

Fuel: Fuel quantity limiter, Injector characteristic, Injector opening time, Per cylinder enrichment multiplier

Fuel pressure: Target fuel pressure, Fuel pressure limiter

Idle speed (if found, TEST): Idle speed in additional mode

Ignition: Ignition advance angle characteristic map, Minimal spark advance, Optimal ignition advance angle, Spark advance idle, Spark advance retardation angle, Spark advance warm-up correction

Input sensors: Temperature sensor conversion curve

Lambda: Power enrichment, Target lambda in additional mode

Torque: Optimal indicated torque, Optimal torque for transmission, Requested torque, Air load limiter, Effective torque limiter, Indicated torque limiter, Torque limiter

Torque Converter - General: Coolant temperature to disable hot mode, Coolant temperature to enable hot mode, Oil temperature for high coolant disable, Oil temperature threshold for high coolant temperature enable, Oil temperature threshold to disable hot mode, Oil temperature to enable hot mode

Automatic transmission: downshift conditions (if present in the file)

Automatic transmission: torque converter (if present in the file)

Automatic transmission: torque converter flex (if present in the file)

Automatic transmission: upshift conditions (if present in the file)

DTC

DTC Table for this module should be created and tested manually to prevent ECU damage, so for URGENT requests DTC table will not be available!

Supported SW list for Module Toyota Denso Petrol 7