Bitedit USB Dongle (with Single Pre-activated Module) ECU Calibration Software Module Toyota Denso Petrol Turbo

Module Toyota Denso Petrol Turbo

Software module for editing calibrations Denso ECU of petrol Toyota | Lexus vehicles with turbo petrol engines with new MCU NEC D76F0xxx.

Firmware filesize 1536/2048 Kb.

Following maps are supported:

Target air filling maps, maximum filling and boost limitation by airmass, torque limitation, boost limitation factors for intake air temperature and knocking, injection time control, closed loop and open loop target lambda, all known sensors scalings, minimal spark advance, spark advance at low/high octane fuel, minimal spark advance for engine protection, spark advance corrections, requested torque, throttle valve actuator position, VVT camshaft control

Vehicles supported:

Lexus NX 200t
Lexus IS 200t
Lexus GS 200t
Lexus RX 200t
Lexus RC 200t
Toyota Crown 2.0t
Toyota Auris 1.2t etc

Engines supported:

8AR-FTS
8NR-FTS
9NR-FTS

To read and write this ECUs u have to use our BitBox module Toyota Denso Petrol newGen

Supported SW list for Module Toyota Denso Petrol Turbo