Original Scania VCI4 Diagnostic Tool - The latest Diag Scania

Scania VCI4 is considered the latest model of Diag Scania, which has a very good power in diagnosing and fixing errors of Scania buses. Scania VCI4 is used to diagnose Scania trucks and buses.

It is Made by ACTIA in Germany

Scania diagnostic device hardware:

· VCI4 interface, Wi-Fi wireless technology with high strength body
· USB cable
· OBD cable

software :

· Xcom software

· SDP 3 software (latest version)

· Scania Multi software (multidiag of heavy vehicles)

Features of the Scania VCI4 diagnostic device:

* Using SDP 3 software to communicate with different ECUs and perform the following activities:
Check the status of the parameters
· Error recovery
· Implementation of diagnostic tests
ECU replacement and parameter programming
Active monitoring and troubleshooting
· View and change ECU configuration
View diagnostic methods and maps
Troubleshooting problems
· Using the information database · Viewing diagnostic methods and maps
· The ability to connect with a network cable
· Use of information database

Capabilities :

*Engine system.
*Gearbox system.
* Retarder system.
*All wheel drive system.
*Clutch control.
*Exhaust emission control.
*Coordinator
*Body system. And ….

The Scania VCI4 diagnostic tool replaces the old Scania diagnostic tool Scania VCI1 and Scania VCI2, and it is designed and built to diagnose new Scania vehicles and heavy vehicle diagnostics.

The unique feature of the Scania VCI4 diagnostic device is the use of wireless technology (Wi-Fi), USB cable and LAN network cable.

Other prominent features of Diag Scania:

*Provide full vehicle specifications

*Display the error codes recorded in the control memory of the units

*Settings and configuration of control units

*Providing information about electrical parts and their locations

*Display parameters of input and output signals

*Test operators

*Replacement parts planning

*Circuit map (separate display of the circuit map related to the related car)

*Information about the systems installed on the vehicle chassis

*Ability to install the program on most computers and notebooks

Softwares :

*Use SDP3 diagnostic software to communicate with Scania trucks and buses and Scania industrial and marine engines.

*It has the ability to communicate with the CAN* electrical system, using the SOPS software to change the SOPS parameters of Scania trucks and buses

*Using XCOM software to program, recover, and restore Scania ECUs, as well as remove immobilizers and immobilizers.

*Using Multi Scania software to access repair shop information - maps and wiring - exploded maps - technical number of spare parts