PCAN-USB PCAN2+ Cummins Diagnostic Adapter Cummins ECM calibration Tool Support Cummins INSITE V8.9 and V9.0

Introduction:

The Cummins Inline 6 tester can only use versions before 8.7, which are stable and effective. After the official upgrade to Cummins Insite Software V8.9 and V9.0 , the Cummins inline 6 tester is no longer suitable.  The new version Cummins Insite Software V8.9 and V9.0 requires the original Cummins inline 7 tester. If you do not have the original Cummins inline 7 tester, you can purchase our PCAN-USB PCAN2+ Cummins Diagnostic Adapter in place, which can also support ECM calibration of Cummins Insite Software V8.9 and V9.0 .

Features:

- A professional automotive bus development tool that supports for pcanexplorer.

- Supports for pcantrace, which enables CAN messages to be quickly recorded, saved, and even replayed on the CAN bus.

- Support ETAS and same star bus development and simulation software.

- Suitable for Linux and for MacOS operating systems.

- Applied to forklifts, construction machinery, and industrial automation.

- Support for CodeSys software for program debugging and downloading of PLC.

- Support for CANmoon software for programming and downloading EPEC and other controllers.

- With optocoupler isolation

- Compatible with German CAN card-USB IPEH-002021 IPEH-002022

- Support for BAIC, Chery and other new energy software

- Support INCA 7.0 7.1 7.2, etc.; can replace es581

- Support ecu computer board calibration, data reading, flashing

- Support epec software

- For Woodward

- Support software for ZAPI

- With 2500V isolation, safe to use

- Support for pcanview, pcanexplorer and other software. As long as software is supported by the the original product, it can also be used by our product

Specification:

- Firmware version: 8.4

- Firmware upgrade: not support

- Supported driver version: 4.2.1 or later

- Chip solution: for Freescale/ST

- USB cable length: 0.8m

Package Included:

- 1 x USB to CAN Adapter

- 1 x DB9 Wiring Terminal Adapter

- 1 x Screw Driver