Bitbox Dongle & Bitbox Module for Trucks Delphi ETC3 Work with Scanmatik 2 PRO SM2 Pro SM3 PRO Programmer

Module for reading and writing through OBD2 connector by CAN-bus Delphi ETC3 ECUs used in trucks DAF, Kenworth, Peterbilt, Hyundai.

DAF/Industrial Delphi ETC3 (FID: 220)

This FID is for working with Delphi ETC3 REV A/B/C ECUs based on MCU NXP MPC5566 with internal flash memory 3 Mb.

Allows reading of calibration area and writing with checksum correction by CANbus. Work possible by OBD2 or on the BENCH.

REV 0 and REV H ECUs are not supported. Hyundai Delphi ETC3 also not supported.

Hyundai Delphi ETC3 (FID: 221)

This FID is for working with Delphi ETC3 ECUs based on MCU NXP MPC5566 with internal flash memory 3 Mb.

Allows reading of calibration area and writing with checksum correction by CANbus. Work possible by OBD2 or on the BENCH.

Attention! Some ECUs have new protection and cannot be supported with this module.