Bitbox Dongle & Bitbox Module for China Bosch Moto/Extreme Work with Scanmatik 2 PRO SM2 Pro SM3 PRO Programmer

FID: 6, 78, 79, 413, 416

Software module to work with Bosch MSE3.0 and US6.0/MSE6.0 and MSE8.0 engine control units. Allows you to identify the software version, virtual read files from our server and to write calibration area with automatic correction checksums on writing.

Bosch MSE3.0 (FID: 6, 78)

ECU is based on MCU ST10F275 with internal memory area 832Kb. Allows Virtual Reading and Writing with CS fixing. If we have no file on server it is possible to read in BSL mode with FID:78.

Bosch MSE6.0/US6.0 (FID: 79)

ECU is based on MCU SPC563M64 with internal memory area 1.5Mb. Allows Virtual Reading (and real reading if no file on server) and Writing with CS fixing. Work is possible on the BENCH only in case that there is no CANbus in diagnostic plug.

Bosch MSE8.0 (FID: 413)

ECU is based on MCU SPC572 with internal memory 1.5Mb. Allows Reading and Writing of calibration area with CS fixing.

Different vehicle producers can have some changes in software identification. If u have any issues during getting ID please try read with no ID and send file to support.

Bosch ME17.8.10 (FID: 416)

ECU is based on MCU Infineon TC1728 with internal memory 1.5Mb. Allows Reading and Writing with CS fixing. Work is possible on the with diagnostic plug or on the BENCH.